MIND THE STEP 2019
  • Mind the step
    • Exhibition >
      • Mind the Step 2018
      • Mind the Step 2017
      • Mind the Step 2016
      • Mind the Step 2015
      • Mind the Step 2014
    • Ambition
  • Mind the Story
  • Press/media
  • Contact
< back to overview
Foto
nshitoot@gmail.com

Xtreme Insoles

Customized 3D printed insoles for competitive cyclists

Reducing the risk of injury and enhancing performance; that’s what Xtreme Insoles stands for. Based on a dynamic plantar pressure analysis and an imprint of the foot in foam, a 3D model of the insoles is created. This is followed by the manufacture of insoles produced via laser sintering with lattice structures of different densities. Through using these insoles when cycling, excessive pressure on the feet is avoided, and so too discomfort and the risk of injuries.​

Gepersonaliseerde 3D-geprinte inlegzolen voor westrijdrenners

De kans op blessures verminderen en prestaties verbeteren; daarvoor staat Xtreme Insoles. Aan de hand van een dynamische druktest tijdens het fietsen en een schuimafdruk van de voet, wordt een 3D-model van de inlegzolen gemaakt. Hierna worden via laser sintering inlegzolen geproduceerd met een rastervormige structuur van verschillende dichtheden. Door tijdens het fietsen de zolen te gebruiken wordt overmatige druk op de voeten vermeden, en daarmee ook ongemak en blessures.

Ninad Shitoot

Industrial Design Engineering, ​Delft University of Technology

Coaches/Researchers: Alice Buso, Maartje van der Bie, Irene Heemskerk, Dennis Sarwin, Olaf Wit
​​
Companies: Low & Bonar, Team Sunweb

Foto

​call us 040 - 247 5388 I  mail us ddw@tue.nl I  visit the exhibition  ​Klokgebouw 50, Strijp-S, 5617 AB Eindhoven
  • Mind the step
    • Exhibition >
      • Mind the Step 2018
      • Mind the Step 2017
      • Mind the Step 2016
      • Mind the Step 2015
      • Mind the Step 2014
    • Ambition
  • Mind the Story
  • Press/media
  • Contact